最高で350-501最新の2024問題集は100%試験合格率保証付きます [Q269-Q292]

Rate this post

最高で350-501最新の2024問題集は100%試験合格率保証付きます

ベストな方法はCisco 350-501練習試験問題集

Cisco 350-501試験は、120分以内に回答する必要がある90〜110の質問で構成されています。この試験は英語と日本語で入手でき、世界中のピアソンvueテストセンターで撮影できます。試験に合格した候補者は、Cisco Certified Specialist -Service Provider Core Certificationを獲得します。これは、サービスプロバイダーネットワーク業界でのスキルと知識の検証として機能します。

新問題 269
Refer to the exhibit:

An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?

Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.

Router 1 is the trigger router in a RTBH implementation.

Router 1 must be configured with uRPF for the RTBH implementation to be effective.

Router 2 is the router receiving the DDoS attack

新問題 270
How much must the MTU be increased when configuring the 802.1q VLAN tag?

2 bytes

4 bytes

8 bytes

12 bytes

新問題 271
Drag and drop the technologies from the left onto the correct definitions on the right.

新問題 272
Refer to the exhibit:

A network engineer is implementing QoS services. Which two statements about the QoS-group keyword on Cisco IOS XR 3re true? (Choose two )

The QoS group numbering corresponds to priority level

QoS group marking occurs on the ingress

It marks packets for end to end QoS pokey enforcement across the network

QoS group can be used in fabric QoS policy as a match criteria

It cannot be used with priority traffic class

新問題 273
Refer to the exhibit. An engineer is trying to implement BGP configuration on a router.
Which configuration error prevents the ASBR from establishing a BGP neighborship to a directly connected BGP speaker?

The routing policy is absent for this Cisco IOS XR eBGP instance.

The IPv4 address family configuration under neighbor configuration-mode must be removed.

The VPNv4 address family interferes with the 8GP IPv4 address family negotiations.

The TCP session parameters are not specified.

新問題 274

Refer to the exhibit. A network engineer is implementing an OSPF configuration. Based on the output, which statement is true?

OSPFv3 does not run for IPv4 on FastEthernet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface FastEthernet0/0.

In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

“IPv6 routing not enabled” is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway.

新問題 275
Refer to the exhibit:

This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?

It is used to set up configuration to poll network data

It is used to enable gRPC

It is used to create a streaming subscription with a 60-second interval

It is used to create a streaming subscription with a 600-second interval

新問題 276
Refer to the exhibit.

A Cisco engineer is implementing gRPC dial-out on an ASR. Receiver 192.168 1.1 will be assigned one of the subscriptions, and it will manage the ASR. Which command is needed to complete the router configuration?

protocol grpc

protocol all

protocol tcp

protocol any

新問題 277
Simulation2
TOPOLOGY
Refer to the exhibit.

新問題 278
Refer to the exhibit. If RC is a stub router, which entry must be injected so that it will send traffic outside the OSPF domain?

virtual link between RB and RC

sham link

more specific route

default route

新問題 279
How can a network administrator secure rest APIs?

They can have a general administrator login for multiple users to access that has command entries logged.

They can authenticate user sessions and provide the appropriate privilege level.

They can ensure that user sessions are authenticated using TACACS+ only.

They can allow read and write privileges to all users.

新問題 280
Refer to the exhibit. An engineer wants to authenticate the OSPF neighbor between PEA and PE- B using MD5.
Which command on PE-B successfully completes the configuration?

PE-B(config-if)#ip ospf message-digest-key 1 md5 44578611
PE-B(config-if)#ip ospf authentication null

PE-B(config-if)#ip ospf message-digest-key 1 md5 44578611
PE-B(config-if)#ip ospf authentication key-chain 44578611

PE-B(config-if)#ip ospf message-digest-key 1 md5 44568611
PE-B(config-if)#ip ospf authentication null

PE-B(config-if)#ip ospf message-digest-key 1 md5 44578611
PE-B(config-if)#ip ospf authentication message-digest

新問題 281
Drag and drop the LDP features from the left onto the correct usages on the right.

新問題 282
Refer to the exhibit. Which statement describes this configuration?

Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session

Router 1 can be remotely managed by the CLI using Telnet

Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only

Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration

新問題 283
What must a network engineer consider when designing a Cisco MPLS TE solution with OSPF?

The OSPF extensions and RSVP-TE must be enabled on all routers in the network.

OSPF extensions for RSVP-TE are supported in Area 1.

The OSPF extensions and RSVP-TE must be enabled on the egress routers.

OSPF extensions for RSVP-TE are implemented in Type 6, 7, and 8 LSAs.

新問題 284
Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

It enables the MPLS core to use EIGRP as the routing protocol.

It enables the Cisco MPLS TE tunnel to be advertised into the running IGP.

It enables the tailend router to advertise routes to the headend router over the tunnel.

It enables the headend and tailend routers to establish a bidirectional tunnel.

新問題 285
You are testing the capabilities of MPLS OAM ping.
Which statement is true?

MPLS OAM ping works solely with Cisco MPLS TE

MPLS OAM ping works solely with P2P LSPs

An LSP breakage results in the ingress MPLS router never receiving any reply

An LSP is not required for the reply to reach the ingress MPLS router

新問題 286
Refer to the exhibit.

The network engineer who manages ASN 65010 is provisioning a customer VRF named CUSTOMER-ABC on PE-2. The PE-CE routing protocol is OSPF Internet reachability is available via the OSPF 0 0 0.0/0 route advertised by CE-1 to PE-1 In the customer VRF Which configuration must the network engineer Implement on PE-2 so that CE-2 has connectivity to the Internet?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

新問題 287
What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

Option A

Option B

Option C

Option D

新問題 288
Refer to the exhibit.

What is the result of this configuration?

Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authorization.

Router 1 and the TACACS+ server maintain one open connection between them only when network administrator is accessing the router with password ciscotest.

Router 1 and the TACACS+ server maintain one open connection between them.

Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authentication.

新問題 289
Refer to the exhibit.

CE1 and CE2 require connectivity to the internet through the ISP connected to PE3 What should an engineer configure to complete this task?

PE2 must be configured to serve as a route reflector for PE3 routes learned from the internet. PE2 then shares the routes with CE1 and CE2.

CE1 and CE2 must be configured with a route distinguisher in the PE1 VRF that dynamically imports the route from the internet.

CE1 and CE2 must be configured to use a static default route with a next-hop of PE3 to reach internet routes.

PE1 must be configured with an import route target in the CE1 VRF that matches the export route target for the internet VRF on PE3.

新問題 290
You are writing an RPL scnpt to accept routes only from certain autonomous systems Consider this code.

If you apply this code to BGP filters, which effect does the code have on your router?

denies routes from AS 7070

allows routes from AS 7077

denies routes from AS 7007

allows routes from AS 770

新問題 291
Refer to the exhibit:

Which information is provided for traceback analysis when this configuration is applied?

BGP version

packet size distribution

source interface

IP sub flow cache

新問題 292
Refer to the exhibit:

An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?