完全版350-501練習テスト373特別な問題と解答が待ってます！ [Q144-Q165]

4.6/5 - (10 votes)

完全版350-501練習テスト373特別な問題と解答が待ってます！

CCNP Service Provider問題集で350-501試験完全版問題で試験学習ガイド

質問144、 Drag and drop the OSs from the left onto the correct deceptions on the right.

質問145、 Which two features will be used when defining SR-TE explicit path hops if the devices are using IP unnumbered interfaces? (Choose two.)

router ID

labels

node address

next hop address

output interface

質問146、 Which additional feature does MPLS DiffServ tunneling support?

matching EXP and DSCP values

PHB layer management

using GRE tunnels to hide markings

interaction between MPLS and IGP

質問147、

Refer to the exhibit. An engineer applied a gRPC dial-in configuration on customer’s router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?

It is used for encoding with the default protocol buffers

It is the encoding requested by the gRPC server

It is the encoding requested by the gRPC client

It is the encoding that is used for dial-in and dial-out

質問148、 Drag and Drop Question
Drag and drop the BGP Best Path Algorithm rules from the left into the corresponding order of importance on the right.

質問149、 Which three OSPF parameters must match before two devices can establish an OSPF adjacency? (Choose three.)

IP address

subnet mask

interface cost

process ID

area number

hello timer setting

質問150、

Refer to the exhibit. Which type of DDoS attack will be mitigated by this configuration?

teardrop attack

smurf attack

SYN flood

SIP INVITE flood attacks

質問151、

Refer to the exhibit. A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment. Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network.
Which action causes the solution to fail?

OSPF does not work with L2VPN services.

The routing protocol network types are not compatible.

A loopback with a /32 IP address has not been used.

The xconnect statement has not been defined.

質問152、 What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

The traffic uses the default MDT to transmit the data only if it is a (S, G) multicast route entry.

A data MDT is created to if it is a (*, G) multicast route entries.

A data and default MDT are created to flood the multicast stream out of all PIM-SM neighbors.

A data MDT is created to allow for the best transmission through the core for (S, G) multicast route entries.

質問153、 Refer to the exhibit.

An engineer is securing a customer’s network. Which command completes this configuration and the engineer must use to prevent a DoS attack?

neighbor ebgp-multihop

ebgp-multihop

ttl-security

neighbor-ttl-security

質問154、 Refer to the exhibit:

P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?

If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP

To support seamless MPLS. TDP must be used as the label protocol

If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP

To support seamless MPLS, the BGP route reflector feature must be disabled

質問155、 Refer to the exhibit.

What does the number 2 mean in the configuration?

It dictates the number of sessions that will be open with the SNMP manager

It represents the version of SNMP running.

It indicates two SNMP managers are able to read and write with the agent using community string ciscotest.

It is the numeric name of the ACL that contains the list of SNMP managers with access to the agent.

質問156、

Refer to the exhibit. Based on the show command output, which result is true after BGP session is established?

The IOS XR router advertises and accepts all routes to and from eBGP neighbor 192.168.2.2.

The IOS XR router advertises all routes to the neighbor 192.168.2.2, but it does not accept any routes from
192.168.2.2.

No routes are accepted from the neighbor 192.168.2.2, nor are any routes advertised to it.

The IOS XR router does not advertises any routes to the neighbor 192.168.2.2, but it accepts any routes from 192.168.2.2.

質問157、 What is the characteristic of the Tl-LFA?

It guarantees a loop-free path for all interfaces in the OSPf- super backbone .

It applies on each area and instance and makes all the interfaces inherit the configuration

It guarantees a loop-free path for all areas configured m OSPF

It applies only on the instance and makes at the interfaces inherit the configuration

質問158、 Refer to the exhibit. The application server in the data center hosts voice, video, and data applications over the internet. The data applications run more slowly than the voice and video applications. To ensure that all applications run smoothly, the service provider decided to implement a QoS policy on router PER 2 to apply traffic shaping. Which two actions must an engineer take to implement the task? (Choose two.)

Configure the scheduling function to handle delayed packets.

Enable packet remarking for priority traffic.

Configure a queue to buffer excess traffic.

Set the token value for secondary traffic.

Set a threshold to discard excess traffic.

質問159、 Refer to the exhibit.

A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network Which action causes the solution to fail?