最近更新された2024年02月テストエンジン練習テストは350-501試験問題解答！ [Q118-Q140]

4/5 - (2 votes)

最近更新された2024年02月テストエンジン練習テストは350-501試験問題解答！

Implementing and Operating Cisco Service Provider Network Core Technologies認定サンプル問題と練習試験合格させます

Cisco 350-501試験は、複数選択問題、シミュレーション、ドラッグ・アンド・ドロップの演習を含むオンラインベースのテストです。試験時間は120分で、合格点は1000点満点の825点です。試験料は400ドルで、登録手続きはPearson VUEのウェブサイトを通じて行うことができます。

質問118、 What is the role of NSO in network automation?

It is GUI used to manage wireless devices in a campus infrastructure.

It Is a type of REST API used to configure an APIC.

It is a tool that uses CLl only to configure virtual network devices.

It is a tool used to bridge automation to the physical network infrastructure.

質問119、 Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.

質問120、 What must a network engineer consider when designing a Cisco MPLS TE solution with OSPF?

The OSPF extensions and RSVP-TE must be enabled on all routers in the network.

OSPF extensions for RSVP-TE are supported in Area 1.

The OSPF extensions and RSVP-TE must be enabled on the egress routers.

OSPF extensions for RSVP-TE are implemented in Type 6, 7, and 8 LSAs.

質問121、 Which three statements about MPLS traffic engineering (MPLS TE) are true? (Choose three)

MPLS TE supports admission control

MPLS TE tunnel traffic is a link attribute to compute the TE tunnel path

MPLS TE uses BGP extension to advertise link attributes

MPLS TE provides protection capability

MPLS TE uses RSVP to establish LSP

質問122、 Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

It enables the MPLS core to use EIGRP as the routing protocol.

It enables the Cisco MPLS TE tunnel to be advertised into the running IGP.

It enables the tailend router to advertise routes to the headend router over the tunnel.

It enables the headend and tailend routers to establish a bidirectional tunnel.

質問123、 Drag and Drop Question
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right.

質問124、 An engineer working for a telecommunication company with an employee ID: 4460:35:466 must configure an OSPF router in a multivendor network so that it performs NSF in the event of a route processor switchover. Which configuration must the engineer apply?

router ospf 1 nsf Cisco

router ospf 1 nsf ietf

router ospf 1 nsf ietf helper

router ospf 1 nsf Cisco helper

質問125、 Which are the two limitations of the predefined NAT solution? (Choose two)

Only the port-presentation option is available

NetFlow and syslog are not supported

The predefined mode cannot be turned on or off during the active translations

Port allocation must be uniform for all subscribers

The global port limit parameter is not available for the predefined mode

質問126、 A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider will connect to these two locations.
What is the next step?

When edge at different regional sites are connected over the global carrier backbone, MP-eBGP must run between routers to exchange the customer VPNv4 routes.

When BGP is used for both route and label exchange, the neighbor a.b.c.d send-label command is used under the address-family VPNv4 command mode.

When IGP used for route exchange and LDP for label exchange, MPLS is enabled only on the VRF interface on the backbone-carrier PE side.

When eBGP is used for label exchange using the send-label option. MPLS-BGP forwarding is configured under the global ABC CSC PE-to-CE interface.

質問127、 A network engineer is configuring Flexible NetFlow and enters these commands

What are two results of implementing this feature instead of traditional NetFlow? (Choose two.)

CPU and memory utilization are reduced.

Only the flows of top 100 talkers are exported.

The data export flow is more secure

The number of packets to be analyzed are reduced.

The accuracy of the data to be analyzed is improved.

質問128、 Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right

質問129、 Refer to the exhibit.

Which configuration must be applied to each of the four routers on the network to reduce LDP LIB size and advertise label bindings for the /32 loopback IP space only?

Option A

Option B

Option C

Option D

質問130、 Which two routing protocols support Cisco MPLS TE Tunnels? (Choose two.)

IS-IS

RIP

BGP

OSPF

EIGRP

質問131、 Refer to me exhibit.

A network operator recently configured BGP FlowSpec for me internal IT network What will be inferred from the configuration deployed on me network?

The policy is configured locally on CSRl and drops all traffic for TCP ports 80 and 443

The policy is learned via BGP FlowSpec and drops all traffic for TCP ports 80 and 443

The policy is warned via BC FlowSpec aid has active traffic

The policy is configured locally on CSR1 and currently has no active traffic

質問132、 An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?

Option A

Option B

Option C

Option D

質問133、 Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0

OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

IPv6 routing not enabled” is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

質問134、 Refer to the exhibit.

Which type of DDoS attack will be mitigated by this configuration?

SYN flood

smurf attack

SIP INVITE flood attacks

teardrop attack

質問135、 Refer to the exhibit:

A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?

It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family

It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration

It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family

It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.

質問136、 Refer to the exhibit.

Refer to the exhibit. A network engineer configures CPE-1 for QoS with these requirements:
IPv4 and IPv6 traffic originated by the CPE-1 WAN IP address must be marked with DSCP CS3.
IPv4 LAN traffic must be marked with DSCP CS1.
IPv6 LAN traffic must be marked with DSCP default.
Which configuration must the engineer implement on CPE-1?

class-map match-any SELF_TRAFFIC
match access-group name SELF_V4
match access-group name SELF_V6
class-map match-all V4_ TRAFFIC
match protocol ip
class-map match-all V6_TRAFFIC
match protocol ipv6
class-map match-all QG_4
match qos-group 4
class-map match-all QG_6
match qos-group 6
!
policy-map LAN-INPUT
class V4_TRAFFIC
set qos-group 4
class V6_TRAFFIC
set qos-group 6
!
policy-map WAN-OUTPUT
class SELF_TRAFFIC
set ip dscp cs3
class QG_4
set ip dscp cs1
class QG_6
set ip dscp default

class-map match-all SELF_TRAFFIC
match access-group name SELF_V4
match access-group name SELF_V6
class-map match-all V4_ TRAFFIC
match protocol ip
class-map match-all V6_TRAFFIC
match protocol ipv6
class-map match-all QG_4
match qos-group 4
class-map match-all QG_6
match qos-group 6
!
policy-map LAN-INPUT
class V4_TRAFFIC
set qos-group 4
class V6_TRAFFIC
set qos-group 6
!
policy-map WAN-OUTPUT
class SELF_TRAFFIC
set dscp cs3
class QG_4
set ip dscp cs1
class QG_6
set dscp default

class-map match-all SELF_TRAFFIC
match access-group name SELF_V4
match access-group name SELF_V6
class-map match-all V4_ TRAFFIC
match protocol ip
class-map match-all V6_TRAFFIC
match protocol ipv6
class-map match-all QG_4
match qos-group 4
class-map match-all QG_6
match qos-group 6
!
policy-map LAN-INPUT
class V4_TRAFFIC
set qos-group 4
class V6_TRAFFIC
set qos-group 6
!
policy-map WAN-OUTPUT
class SELF_TRAFFIC
set ip dscp cs3
class QG_4
set ip dscp cs1
class QG_6
set ip dscp default

class-map match-any SELF_TRAFFIC
match access-group name SELF_V4
match access-group name SELF_V6
class-map match-all V4_ TRAFFIC
match protocol ip
class-map match-all V6_TRAFFIC
match protocol ipv6
class-map match-all QG_4
match qos-group 4
class-map match-all QG_6
match qos-group 6
!
policy-map LAN-INPUT
class V4_TRAFFIC
set qos-group 4
class V6_TRAFFIC
set qos-group 6
!
policy-map WAN-OUTPUT
class SELF_TRAFFIC
set dscp cs3
class QG_4
set ip dscp cs1
class QG_6
set dscp default

質問137、 Drag and drop the message types from the left onto the target field of the message originator on the right.

質問138、 Which configuration modifies Local Packet Transport Services hardware policies?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

質問139、 What do Chef and Puppet have in common?

use Ruby

use a master server

require modules to be created from scratch

manage agents referred to as minions

質問140、 Refer to the exhibit.

Refer to the exhibit. The application server in the data center hosts voice, video, and data applications over the internet. The data applications run more slowly than the voice and video applications. To ensure that all applications run smoothly, the service provider decided to implement a QoS policy on router PER 2 to apply traffic shaping. Which two actions must an engineer take to implement the task? (Choose two.)

Configure the scheduling function to handle delayed packets.

Enable packet remarking for priority traffic.

Configure a queue to buffer excess traffic.

Set the token value for secondary traffic.

Set a threshold to discard excess traffic.

Cisco 350-501試験は、Ciscoサービスプロバイダネットワークコアテクノロジーの実装と運用に関するスキルと知識を検証したいITプロフェッショナルを対象として設計されています。この認定試験は、ネットワークアーキテクチャ、仮想化、自動化、セキュリティ、ネットワークサービスなど、幅広いトピックをカバーしています。合格した候補者は、Ciscoテクノロジー、ベストプラクティス、および標準を使用して、複雑なサービスプロバイダネットワークソリューションを計画、実装、トラブルシューティングできる能力を示します。

認定問題集でCCNP Service Provider 350-501ガイドで100%有効な：https://www.passtest.jp/Cisco/350-501-shiken.html