究極のガイド準備300-430認証試験CCNP Enterpriseは2024年更新 [Q119-Q143]

質問 119
Refer to the exhibit.

A customer has implemented Cisco FlexConnect deployments with different WLANs around the global and is opening a new branch in a different location. The engineers’ task is to execute all the wireless configuration and to suggest how to configure the switch ports for new Aps. Which configuration must the switching team use on the switch ports?

質問 120
An engineer is implementing RADIUS to restrict administrative control to the network with the WLC management IP address of 192.168.1.10 and an AP subnet of 192.168.2.0/24. Which entry does the engineer define in the RADIUS server?

質問 121
The security learn is concerned about the access to all network devices, including the Cisco WLC. To permit only the admin subnet to have access to management, a CPU ACL is created and applied. However, guest users cannot get to the web portal. What must be configured to permit only admins to have access?

質問 122
Which feature on the Cisco Wireless LAN Controller must be present to support dynamic VLAN mapping?

質問 123
Refer to the exhibit.

The image shows a packet capture that was taken at the CLI of the Cisco CMX server. It shows UDP traffic from the WLC coming into the server. What does the capture prove?

質問 124
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?

質問 125
An engineer configures a deployment to support:
Cisco CMX
licenses for at least 3000 APs
6000 wIPS licenses
The Cisco vMSE appliance must be sized for this deployment. Which Cisco vMSE Release 8 option must the engineer deploy?

質問 126
What is the difference between PIM sparse mode and PIM dense mode?

質問 127
An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?

質問 128
Refer to the exhibit.

An engineer is creating an ACL to restrict some traffic to the WLC CPU. Which selection must be made from the direction drop- down list?

質問 129
Refer to the exhibit.

The image shows a packet capture that was taken at the CLI of the Cisco CMX server. It shows UDP traffic from the WLC coming into the server. What does the capture prove?

質問 130
An engineer wants the wireless voice traffic class of service to be used to determine the queue order for packets received, and then have the differentiated services code point set to match when it is resent to another port on the switch. Which configuration is required in the network?

質問 131
Refer to the exhibit.

Which area indicates the greatest impact on the wireless network when viewing the Cisco CleanAir Zone of Impact map of interferers?

質問 132
An engineer must implement intrusion protection the WLAN. The AP coverage is adequate and on-channel attacks are the primary concern. The building is historic, which makes adding APs difficult. Which Ap mode and submode must be implemented?

質問 133
An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

質問 134
When configuring a Cisco WLC, which CLI command adds a VLAN with VLAN ID of 30 to a FlexConnect group named BranchA-FCG?

質問 135
When implementing self-registration for guest/BYOD devices, what happens when an employee tries to connect four devices to the network at the same time?

質問 136
Refer to the exhibit.

A wireless engineer has integrated the wireless network with a RADIUS server. Although the configuration on the RADIUS is correct, users are reporting that they are unable to connect. During troubleshooting, the engineer notices that the authentication requests are being dropped. Which action will resolve the issue?

質問 137
A customer requires wireless traffic from the branch to be routed through the firewall at corporate headquarters. A RADIUS server is in each branch location. Which Cisco FlexConnect configuration must be used?

質問 138
Branch wireless users report that they can no longer access services from head office but can access services locally at the site. New wireless users can associate to the wireless while the WAN is down. Which three elements (Cisco FlexConnect state, operation mode, and authentication method) are seen in this scenario? (Choose three.)

質問 139
An enterprise started using WebEx as a virtual meeting solution. There is a concern that the existing wireless network will not be able to support the increased amount of traffic as a result of using WebEx. An engineering needs to remark the QoS value for this application to ensure high quality in meetings. Which must be implemented to accomplish this task?

質問 140
What is the default IEEE 802.1x AP authentication configuration on a Cisco Catalyst 9800 Series Wireless Controller?

質問 141
Which two configurations are applied on the WLC to enable multicast, check multicast stream subscriptions, and stream content only to subscribed clients? (Choose two)

質問 142
Which component must be integrated with Cisco DNA Center to display the location of a client that isexperiencing connectivity issues?

質問 143
An engineer must configure a Cisco WLC to support Cisco Aironet 600 Series OfficeExtend APs. Which two Layer 2 security options are supported in this environment? (Choose two.)