[2023年04月] 100%リアル 156-835 試験解答 正確で検証済みの問題集リアル試験問題をゲット! [Q18-Q42]

18、In case of Correction, where is information about Owner stored?

19、For a VSX configuration – Which statement is wrong?

20、Which command will be used in order to restart Orchestrator service only?

21、Orchestrator should be defined in SmartConsole as:

22、What is the default IP range of Sync network (with no increment)?

23、What cannot be learned from the output of lldpctl?

24、What kind of cluster Dual-Site can be compared to?

25、What is the maximum amount of Appliances within Security group in Dual-Site configuration?

26、What cannot be learned from the output of asg perf -v -p command?

27、What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

28、What kind of cluster Dual-Site can be compared to?

29、What is the distribution mode?

30、Which is a valid requirement for a supported Maestro appliance?

31、What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

32、What does asg monitor command do?

33、For a VSX configuration – Which statement is wrong?

34、There is a Security group of 10 Appliances and all of them are up and running. How many Appliances within a Security Group keep the same connection in its connection table in case of NAT?

35、Complete the sentence: When using a Break-out cable…

36、Which file on Appliance includes information about Security Group?

37、What cannot be a reason for DETACHED status of Appliance when running asg monitor command?

38、What type of cluster can a Security Group can be compared to?

39、When running asg perf -v in a Dual-Site environment, we can see only Appliances from one of the sites. That means we’re working in:

40、What command will be used for updating fwkern.conf file on all Appliances within Security Group?

41、What kinds of transceivers are supported on Orchestrator MHO-140?

42、What is the maximum amount of Appliances within the same Security Group?