GB0-342-ENUのPDFで合格させるスゴ問題集でGB0-342-ENU最新のリアル試験問題 [Q95-Q116]

95、The Wi-Fi Alliance is a non-profit international association established in 1999 to certify the interoperability of wireless LAN products based on the IEEE 802.11 specification and to promote the formulation of new wireless standards. Interoperability (eg wireless connectivity, encryption, roaming, etc.).
Which of the following are protocol standards proposed by the Wi-Fi Alliance?

96、Which of the following commands can view the detailed information in the H3C wireless controller, such as the IP address obtained by the AP?

97、Which of the following wireless WLAN PHY layer protocols can only work in the 5G frequency band?

98、The wireless AP has FAT and FIT modes, in which the default AP address in FAT mode is ___ (single choice)
Default username: admin Default password: h3capadmin

99、Which of the following statements about digital bandwidth vs analog bandwidth is true

100、Regarding the local forwarding function of FIT APs, the following statements are correct:

101、Which of the radio link handover control parameters is correct?

102、Which of the following descriptions for the SSID hiding function is correct?

103、In H3C’s intelligent management center (MC), what is the component used to realize wireless service management?

104、Which of the following is true for the AP installation specification description:

105、(Single choice) Which of the following is the correct description of the process of CAPWAP negotiation from AP to AC?

106、When planning a WLAN network, the first consideration should be the effective interaction of wireless signals between APs and wireless terminals, followed by the effective broadband access to users.

107、The point-to-point communication between different STA clients under the same FIT AP is correct.

108、What modules are included in the WLAN optimization service product:

109、When the H3C AP is directly connected to the wireless switch or connected through a Layer 2 network, the correct registration steps are:
1. The AP sends a Layer 2 broadcast discovery request message to try to contact a wireless switch
2. The AP downloads the latest software version and configuration from the wireless switch
3. The wireless switch that receives the discovery request message will check whether the AP has the right to access the machine, and if so, it will respond with a discovery response
4. AP obtains IP address through DHCP server
5. The AP starts to work normally and the wireless switch exchanges user data packets

110、The signal strength RSSI displayed by the wireless device can directly reflect the quality of the link, but in fact, due to the fact that the noise floor is related to the environment and interference, it will change from time to time; while the SNR is relatively stable (for a fixed environment and transmit power), it can be considered and transmitted Power, the antenna used by the device, the distance of the device, and spatial attenuation are related, but after the device is installed, the SNR is often relatively fixed.
Which of the following statements about the relationship between bottom and RSSI is correct.

111、What steps does the wireless optimization of personnel input include at the specific operational level?

112、On the H3C wireless controller, wireless users connected to the same SSID can be assigned to different VLANs. The specific methods are ______

113、The theoretical maximum transmission rate of WLAN usually refers to the transmission rate of large-byte (1500 bytes) packets, but in most networks, there are many small-byte (below 250 bytes) packets, which will seriously affect the practical application of WLAN. performance, making it well below the theoretical maximum rate. The above statement is true.

114、The wrong description for WLC support for IRF stacking is _____.

115、Place the antenna at a high place and maintain a certain down-tilt angle to cover the outdoor space; it is suitable for WLAN coverage in outdoor open/semi-open areas.

116、During the Layer 2 registration of the Fit AP, it is found that the AP is in the Idle state on the AC. The possible reasons are as follows.