NS0-520のPDF問題集リアル2022最近更新された問題 [Q57-Q78]

質問 57
Which topology allows for guaranteed maximum network performance for iSCSI?

質問 58
Click the Exhibit button.

An administrator is trying to configure a multiple-hop Cisco MDS switch and is receiving the error shown in the exhibit.
In this scenario, which action will solve this problem?

質問 59
You are planning few a new AFF A700 2-node switchless FC solution with two Cisco 9100 switches. Each AFF A700 will have one 16 Gb port Connected to each Cisco 9100 switch and four FC LIKs per physical port. You want to guarantee recovery from connection loss on a NetApp physical port and you are using single initiator to multiple target zoning.
What is the minimum number of zones required to accomplish this task?

質問 60
Exhibit.

You need to configure the SnapCenter Plug-in for VMware vSphere to back up and restore VMware datastores.
Referring to the exhibit, which additional LIF type should you create before you configure the plug-in?

質問 61
You are installing a NetApp FAS6040 high availability storage system. Which cfmode should be set to ensure proper failover in an HP-UX environment?

質問 62
An administrator has an ONTAP cluster with SVMs and LUNs as shown in the exhibit. Hosts attempting to connect to LUNs mapped from SVM “C” are unable to see their LUNs. The hosts are not configured to connect to any other SVM.
Which action should be performed to restore multi-path connectivity to the LUNs in this scenario?

質問 63
A storage administrator needs to ensure that an ONTAP FC LUN is accessible for a remote data center. The ISL ports are reporting errors. The trunkshow command output from a Brocade switch is shown below.

質問 64
Exhibit.

Referring to the exhibit, what is the total number of target LUNs that are being accessed?

質問 65
An ONTAP administrator is troubleshooting a fabric login issue with a client. The SVM in question uses both FC and NFS protocols.
In this scenario, what would be the least disruptive operation?

質問 66
You have a new 2-node AFF All SAN Array A700 cluster serving iSCSI LUNs. You are asked to test failures of the storage back-end subsystem.
In this scenario, which two actions satisfy the failure criteria? (Choose two.)

質問 67
An administrator has taken over managing an AFF A320 4-node SAN environment with several attached hosts. The administrator is asked to inventory the environment before performing firmware updates.
In this scenario, which two tools would satisfy the requirement? (Choose two.)

質問 68
A customer needs to change ports 0e and 0f on AFF_1 to support FC.
Referring to the exhibit, which three steps are required to accomplish this task? (Choose three.)

質問 69
After the addition of extra DS224C disk shelves, you notice that the output of the system node run -node node_1 sysconfig command shows Mixed-path. You need to investigate why the additional shelves are providing this error.
In this scenario, which two tools would help diagnose this issue? (Choose two.)

質問 70
A customer has an AFF A700 connected to a Cisco switch and has verified connectivity but cannot see any LUNs. The customer issued the run -node scaling-01 -command fcp topology show command to verify the connection.
Referring to the exhibit, what needs to be enabled on the Cisco switch?

質問 71
An administrator who is using the Virtual Storage Console (VSC) creates a new FC datastore on an existing volume. While the datastore was provisioned, two hosts were in maintenance mode. When the maintenance was completed, the two hosts do not have access to the new datastore, but they have access to other datastores on the same volume.
In this scenario, what caused this result?

質問 72
An administrator is asked to provision a SAN environment in which host applications can monitor LUN space and performance space reclamation.
Which LUN type would satisfy these requirements?

質問 73
What is a prerequisite for enabling SCSI UNMAP support for SAN attached hosts?

質問 74
You are connecting an ISL between two Brocade switches on ports 20 and 21.
Which port-channel type should you configure?

質問 75
Exhibit.

The exhibit shows the Inn show command output for the oradata oraFinProd_l LUN.
Which two statements ate correct about the LUN’? (Choose two.)

質問 76
In a Linux environment, issues are reported concerning multipathing. You want to view the direct and indirect paths. In this scenario, which command would you use to accomplish this task?

質問 77
Which option needs to be set on a LUN to guarantee that it cannot be affected by other LUNs in the volume?

質問 78
You have implemented FabricPool on your AFF ASA ONTAP 9.8 Cluster. An archived database has become very active, and it requires FabricPool adjustments.
Which two steps are required to address this issue? (Choose two)