Huawei H31-341-ENU認定試験問題集には215練習テスト問題があります [Q43-Q63]

43、Which of the following statements are wrong about TE links? (Multiple Choice)

44、NS4 as 100G line service processing board. In the following description of the NS4 board, which is wrong?

45、Which particles can be cross-scheduled for the cross-board of the OSN 8800 device? (Multiple choice)

46、Which of the following statements about the latency of a storage and forwarding device is false?

47、The maximum optical power of light-emitting OBU output is 20dBm, which is used in the C-band 80 system. How much dBm should the single-wave standard output optical power be?

48、Which of the following statements about the advantages of OTN are wrong?

49、When the NNI port attribute is configured on the same subnet, the IP addresses of the ports on different links can be duplicated.

50、The E-Line service types supported by the MS-OTN packet device are: (Multiple Choice)

51、What are the classification of Ethernet performance tests? (Multiple choice)

52、Which of the following is a good way to avoid creating discrete paths? (Multiple Choice)

53、Which of the following is the data that needs to be collected and saved in the event of a failure? (Multiple Choice)

54、FOADM includes parallel FOAD and serial FOADM, both supporting 40 waves or 80 waves of arbitrary wavelengths.

55、Which of the following statements about the modulation technologies of the 40Gbit/s and 100Gbit/s coherent systems are correct?

56、In the ROADM, which of the following layer of OTN paths do not need to be manually configured, it can be obtained directly by path search? (Multiple Choice)

57、When using the OSN8800 T32, if you want to set the ID number of the master and slave sub-racks, which board should be set?

58、After starting the extended SSM protocol, in addition to determining the clock quality level and priority, the clock ID is also determined. After receiving the clock signal with the ID, the network element considers that the source is unavailable if it is judged to be the clock signal sent by the station. In this way, even after passing through multiple sites, the network element can still recognize the clock signal sent by itself, preventing the formation of a timing loop.

59、Which of the following is the client-side logical port of a board in standard mode?

60、The E&M signal defines the type of connection between a relay device and a signaling unit. Which of the following belongs to the relay device?

61、Which of the following device types support the master-slave sub-architecture mode? (Multiple Choice)

62、The OTN circuit board (such as ND2) of OSN 1800V can respond to the status of the indicator light on the panel to reflect the optical power of the local end too high or too low.

63、For a 10G OTU board, the receiving end optical module uses PIN module. Which of the following receiving powers is in the normal receiving range of the board?