[2026年09月16日]NS0-094試験ブレーン問題集で学習注釈と理論 [Q79-Q99]

質問 79
During a controller replacement procedure, the engineer notices that the replacement controller boots into Loader mode instead of ONTAP. Which action should be performed NEXT?

質問 80
A new NetApp NS224 disk shelf is correctly cabled to a NetApp AFF HA pair. The disks show up as single-path. Which action corrects the issue?

質問 81
You must replace a disk shelf due to a hardware fault on a NetApp ONTAP cluster. You replace the shelf with a new shelf that originally belonged to another cluster, and some disks in the new shelf are not showing up as spares. When you run the disk show command, you notice that the new disks have “foreign” ownership. When you attempt to assign the disks, the attempt fails with an ownership conflict error. Which procedure resolves the disk ownership issue and makes the new disks available as spares?

質問 82
A Field Service engineer has just replaced a motherboard in a NetApp ONTAP based system.
The system will not boot, but it shows the following message:

What does the engineer do to troubleshoot the boot media?

質問 83
A customer accidentally removes the incorrect disk during a maintenance procedure on a RAID- DP aggregate. Which outcome is MOST likely if another disk fails before reconstruction completes?

質問 84
While troubleshooting a RAID group, you notice that one disk shows consistently higher utilization than the other disks.
Refer to the following output:

What action do you take to correct this issue?

質問 85
You have created a case with NetApp Support for an issue with a DS4246 shelf on an ONTAP
9.12.1 system. They have requested that you provide shelf logs. What action do you need to take to collect the shelf logs?

質問 86
A newly installed shelf shows one SAS path as down while multipath HA is enabled. What is the MOST likely result if another path fails?

質問 87
A customer has one large aggregate over several shelves, and only one shelf has reached End of Support (EoS) and needs to be evacuated. The installation engineer already added a new shelf and assigned the disks with same type and size. Which NetApp ONTAP command is used to copy the data from disk to disk?

質問 88
A company is performing a hardware refresh on a 2-node switched NetApp ONTAP cluster. They need to replace two older nodes that support only ONTAP releases earlier than ONTAP 9.8 software with two NetApp AFF systems that require ONTAP 9.12.1 or later releases. The cluster is currently running ONTAP 9.7. Which steps complete the hardware refresh with all nodes running on ONTAP 9.12.1 software without disruption?

質問 89
Which two of the following are field replaceable units (FRUs) on an AFF A220 system? (Choose two.)

質問 90
A customer observes that one node repeatedly enters takeover mode due to thermal alarms.
Which FRU should be inspected FIRST?

質問 91
After replacing a failed controller, the engineer notices mismatched firmware versions between HA partners. What is the BEST action?

質問 92
You need to upgrade your cluster switches to a new version of firmware. Which command do you use to prevent automatic case creation?

質問 93
A new disk shelf was added to a NetApp ONTAP cluster nondisruptively. After using the disk show command, some of the disks in the shelf are not visible in the system. What is causing this issue?

質問 94
A customer observes that one node repeatedly enters takeover mode due to thermal alarms.
Which FRU should be inspected FIRST?

質問 95
A customer opened a support ticket with this error message:
Mon Oct 17 19:16:56 +0800 [Nodename: dsa_disc:
callhome.dsk.redun.fault:error]: Call home for DISK REDUNDANCY FAILED
What is the cause of the EMS message in the event log?

質問 96
Which statement about the 2.1.3 drive is true?

質問 97
During a new SVM deployment, all of the FC LIFs are showing an admin/oper status of up/down.
The LIF extended status is Waiting for Link. What is causing this status?

質問 98
You have an air-gapped NetApp ONTAP based system that has recently had a node panic, and the node is back online. To assist in troubleshooting, the NetApp Support team has asked you to submit the core file for analysis. Which two methods do you use to access the core files from the ONTAP controllers in this environment? (Choose two.)

質問 99
At what stage is a write acknowledged to a client?